M

Magnetic Walnut Key Holder

Succulents are great low maintenance, indoor plants that can be used to add life to any room. This DIY succulent wood planter looks great as a centerpiece on a table or can be wall mounted with a couple of L-brackets.
I made the planter from a short piece of a 4×4 post by drilling 2” diameter holes 2.5” deep and coating it with Minwax Polycrylic to make it waterproof.
I created a simple one with three holes for plants first and then tried a really cool series of faceted planters with asymmetrical holes for the plants.

Five or six of these planters could be made out of a single 8 foot long 4×4, which makes this an excellent option for DIY gifting.

 

 

“Until you dig a hole, you plant a tree, you water it and make it survive, you haven’t done a thing. You are just talking.”

– Wangari Maathai

Project Details

Check out exactly how I did it and good luck making your own succulent planter.

Materials

  • (1) 4×4
  • (1) 5/16 Dowel
  • (x) Sanding Paper 60-220 Grit
  • (x) Rag or Stain/Foam Brush
  • (1) Minwax Polycrylic
  • (1) L-Bracket (Optional)

Tools

  • – Cordless Drilll or Drill Press
  • – Circular Saw or Miter Saw
  • – Orbital Sander
  • – 10″ 5/16 Drill Bit
  • – 2″ Forstner Bit


Cut List

  • (1) 14″ 4×4 (Length can be custom)
  • (3) 2″ Diameter Holes (can be custom depending on length of your 4×4 cut)


Directions

  1. Make your cuts – Cut a 14” long piece of 4×4. It’s easiest to do this with a compound miter saw. You can aslo cut it with a circular saw, but you’ll have to make two cuts since it’s thick.
  2. Drilling the Housing – I drilled three evenly spaced 2” diameter holes using a Forstner drill bit. Forstner bits are perfect for this application since they leave flat bottom holes and come in large diameters. When drilling large diameter holes, there’s a lot of torque on the drill and your wrists, so it’s a good idea to firmly clamp the piece you’re drilling to a work surface so that you can have both hands on the drill. I drilled the holes 2.5” deep.
  3. Drain Hole – I used my extra long 1/4″ diameter drill bit to drill one long hole through the side of the planters and connected the bottoms of the three 2” diameter holes. This hole will let the planters drain
  4. Sanding – Use an orbital sander to sand the planter smooth and round over the edges. I started with 60 grit pads and finished with 220 grit.
  5. Seal the Wood. – I brushed a coat of Minwax Polycrylic onto the 4×4 to seal it.
  6. The Plug – I carved the end of the 5/16” diameter dowel into a tapered plug to fit in the drainage hole. Then I cut off an end of the dowel to make a plug about 1” long. I stuck the plug in and tested the planter by pouring water into it.
  7. Placement – I placed three small succulents on a shelf, but you can use the L-brackets to mount it on a wall.

Lessons Learned: Make sure you have a long drill bit that will reach the 3rd housing. Also make sure that the drill bit you use is one fraction smaller than the dowell size desired.

Leave a Reply

Your email address will not be published. Required fields are marked *